The MDSS96 surface spline is 95 1/2" long, is attached with Strong-Drive® SDS Heavy-Duty Connector screws and is an ideal solution for CLT diaphragms. For CLT manufacturers, it reduces costs by eliminating or reducing time for milling at panel edges. And since our tabulated values are based on tests, not just calculations, Designers can value-engineer a solution using fewer screws than calculated solutions would allow.

Key Features

Pre-punched screw holes speed fastener installation

Tested loads allow for value-engineered solutions using fewer screws than calculated solutions would allow

Reduces or eliminates the need for edge-milling of CLT panels

Material

14 ga.

Finish

Galvanized (G90)

Installation

Use all specified fasteners/anchors